FluidNC Error 22

FluidNCErrorPosition is kept

A cutting move came before any feed rate (F) was set.

Position is kept. An error means the controller refused that one line or command, so nothing moved for it. (Hamrun's reading)
What to do
  1. Add a feed rate (like F1000) to the first cutting move, or have your CAM output one.
  2. Check the post-processor writes F on the first G1.
Official FluidNC message: “Gcode undefined feed rate” source

Got a different message?

Paste it into the decoder. Hamrun's editor checks your G-code before you run it, so a toolpath that leaves the machine's travel or a missing feed rate is caught before the machine stops.

Related codes

Official text copied from the FluidNC source on 2026-11-01. Steps and the position answer are Hamrun's reading unless marked “firmware says”. User reports are labelled CLAIMED.