uCNC Alarm 1

uCNCAlarmPosition is lost: home again

A limit switch was hit while the machine was moving, so the controller stopped dead.

Position is lost: home again. The stop is instant, so the motors can skip steps. (Hamrun's reading)
What to do
  1. Look at which axis is sitting on its switch, and why: a job too big for the bed, or a work zero set too close to the edge.
  2. Reset the controller, then unlock ($X) and jog the machine off the switch.
  3. Home the machine, then set your work zero again before restarting the job.
  4. If the switch triggers when nothing touches it, check its cable for a pinch, loose plug or a cable chain pressing on it.
What users reported CLAIMED · forum and issue reports, not official
  • Repeated Alarm 3 and Error 9 mid-cut on a 3018 Pro. First blamed on electrical noise; the real cause was the cable chain nudging the Z limit switch. (one owner's report) r/hobbycnc thread, Jul 2026
Name in the uCNC source: EXEC_ALARM_HARD_LIMIT. The meaning above is in Hamrun's words; uCNC's own message text isn't copied here. source

Got a different message?

Paste it into the decoder. Hamrun's editor checks your G-code before you run it, so a toolpath that leaves the machine's travel or a missing feed rate is caught before the machine stops. Have the whole file? Check it here, free: it finds the line that triggers this, and the file never leaves your computer.

Related codes

  • GRBL 1.1 Alarm 1: A limit switch was hit while the machine was moving, so the controller stopped dead.
  • grblHAL Alarm 1: A limit switch was hit while the machine was moving, so the controller stopped dead.
  • FluidNC Alarm 1: A limit switch was hit while the machine was moving, so the controller stopped dead.
  • Grbl_Esp32 Alarm 1: A limit switch was hit while the machine was moving, so the controller stopped dead.

Code name taken from the uCNC source on 2026-11-10; the meaning is in Hamrun's words and uCNC's message text isn't copied. Steps and the position answer are Hamrun's reading unless marked “firmware says”. User reports are labelled CLAIMED.