uCNC Alarm 10

uCNCAlarmPosition isn't set yet: home first

On a machine with two motors on one axis, the second limit switch wasn't found when squaring.

Position isn't set yet: home first. Homing didn't finish. (Hamrun's reading)
What to do
  1. Check the second switch on that axis the same way as the first: press it by hand and watch the pin state.
  2. Check both sides of the gantry move freely and the switch is where the axis can reach it.
Name in the uCNC source: EXEC_ALARM_HOMING_FAIL_DUAL_APPROACH. The meaning above is in Hamrun's words; uCNC's own message text isn't copied here. source

Got a different message?

Paste it into the decoder. Hamrun's editor checks your G-code before you run it, so a toolpath that leaves the machine's travel or a missing feed rate is caught before the machine stops. Have the whole file? Check it here, free: it finds the line that triggers this, and the file never leaves your computer.

Related codes

  • GRBL 1.1 Alarm 10: On a machine with two motors on one axis, the second limit switch wasn't found when squaring.
  • grblHAL Alarm 15: On a machine with two motors on one axis, the second limit switch wasn't found when squaring.
  • uCNC Alarm 6: Homing was interrupted by a reset before it finished.
  • uCNC Alarm 7: The safety door was opened during homing.
  • uCNC Alarm 8: After touching a limit switch, the machine backed off but the switch still read as pressed.
  • uCNC Alarm 9: During homing an axis travelled as far as it's allowed to and never found its limit switch.

Code name taken from the uCNC source on 2026-11-10; the meaning is in Hamrun's words and uCNC's message text isn't copied. Steps and the position answer are Hamrun's reading unless marked “firmware says”. User reports are labelled CLAIMED.