uCNC Alarm 12

uCNCAlarmNot a position problem

The spindle couldn't hold the steady, synced speed that a synced move (like threading) needs.

Not a position problem. Hamrun's reading: uCNC checks the sync before the synced move. If the job stopped mid-cut, home before trusting position. (Hamrun's reading)
What to do
  1. Check the spindle encoder or index signal is connected and reading.
  2. Try a lower spindle speed for the synced move.
  3. If the job stopped mid-cut, home the machine before restarting.
Name in the uCNC source: EXEC_ALARM_SPINDLE_SYNC_FAIL. The meaning above is in Hamrun's words; uCNC's own message text isn't copied here. source

Got a different message?

Paste it into the decoder. Hamrun's editor checks your G-code before you run it, so a toolpath that leaves the machine's travel or a missing feed rate is caught before the machine stops. Have the whole file? Check it here, free: it finds the line that triggers this, and the file never leaves your computer.

Code name taken from the uCNC source on 2026-11-10; the meaning is in Hamrun's words and uCNC's message text isn't copied. Steps and the position answer are Hamrun's reading unless marked “firmware says”. User reports are labelled CLAIMED.