uCNC Alarm 15

uCNCAlarmNot a position problem

Something went wrong during an automatic tool change.

Not a position problem. Hamrun's reading: it depends on where the change stopped. Check the tool, then home before trusting position. (Hamrun's reading)
What to do
  1. Look at the tool changer: is a tool half-dropped, or the rack out of place?
  2. Check the tool number in the file exists in your tool table.
  3. Home the machine, then set your work zero again before restarting the job.
Name in the uCNC source: EXEC_ALARM_ATC_ERROR. The meaning above is in Hamrun's words; uCNC's own message text isn't copied here. source

Got a different message?

Paste it into the decoder. Hamrun's editor checks your G-code before you run it, so a toolpath that leaves the machine's travel or a missing feed rate is caught before the machine stops. Have the whole file? Check it here, free: it finds the line that triggers this, and the file never leaves your computer.

Code name taken from the uCNC source on 2026-11-10; the meaning is in Hamrun's words and uCNC's message text isn't copied. Steps and the position answer are Hamrun's reading unless marked “firmware says”. User reports are labelled CLAIMED.