uCNC Alarm 4
uCNCAlarmPosition is kept
The probe already looked touched (or untouched, for a probe-away move) before probing even started.
Position is kept. The probe cycle stopped before moving. (Hamrun's reading)
What to do
- Check the probe isn't already touching: the clip on the bit and the plate under it shouldn't meet before the move.
- Touch the clip to the plate by hand and see whether your sender's probe light changes. If it's always on, the probe input is inverted ($6) or the wire is shorted.
- Unlock and try the probe again.
Name in the uCNC source:
EXEC_ALARM_PROBE_FAIL_INITIAL. The meaning above is in Hamrun's words; uCNC's own message text isn't copied here. sourceGot a different message?
Paste it into the decoder. Hamrun's editor checks your G-code before you run it, so a toolpath that leaves the machine's travel or a missing feed rate is caught before the machine stops. Have the whole file? Check it here, free: it finds the line that triggers this, and the file never leaves your computer.
Related codes
- GRBL 1.1 Alarm 4: The probe already looked touched (or untouched, for a probe-away move) before probing even started.
- grblHAL Alarm 4: The probe already looked touched (or untouched, for a probe-away move) before probing even started.
- FluidNC Alarm 4: The probe already looked touched (or untouched, for a probe-away move) before probing even started.
- Grbl_Esp32 Alarm 4: The probe already looked touched (or untouched, for a probe-away move) before probing even started.
Code name taken from the uCNC source on 2026-11-10; the meaning is in Hamrun's words and uCNC's message text isn't copied. Steps and the position answer are Hamrun's reading unless marked “firmware says”. User reports are labelled CLAIMED.